In those cases the culprit might be a gfci outlet that has tripped.
Fuse box circuit breaker tripped.
No continuity indicates a break in the wire.
If it stays on plug the appliances back in one by one until it trips again and service or discard the appliance that makes it trip.
However in some cases the breaker or fuse may seem fine and even if you reset the circuit breaker the circuit is still dead.
When a fuse blows a metal filament inside the fuse has burned through meaning that you ll need to replace the fuse with a new one.
For safety it s a good idea to stand back or to the side of the panel for safety just in case any sparks come from the breaker when it s moved or to wear safety goggles when resetting a circuit breaker.
They provide more accurate protection than traditional wire fuses.
To reset a tripped circuit breaker turn off the breaker by moving the switch or handle to the off position and then turn it back on.
Twist the set of wires together at the receptacle box and check the wires at the panel box end with the continuity checker on your voltage meter.
Unplug all appliances that are plugged into outlets on that circuit and turn off all the lights then try the breaker again.
This means that the flow of electricity is cut off to keep your circuits from overheating or causing more damage.
Rcds residual current devices switches that will trip and turn off the electricity if the circuit they manage is considered dangerous.
Switch the main circuit breaker to the off position.
If there were no circuit breaker trips then house fires would have been quite a common issue.
When an appliance or light fixture suddenly goes dead it is very likely that a circuit breaker has tripped and interrupted the power flowing to the electrical circuit.
Check each appliance for overheating when you unplug it.
If your fuse switch has tripped after you ve been using a lot of appliances in one room you ve likely overloaded the circuit.
The simple answer is to unplug some of them and move the tripped fuse switch in your fuse box back to the on position.
When the lights go out in one or more rooms or in a series of electrical outlets the culprit is sometimes a circuit breaker or a fuse has blown.
To test for circuit overload the next time the breaker trips go to the electrical panel and turn off all the switches in the affected area and unplug all appliances lamps and other devices.
In the case of circuit breakers the immediate answer is to find the breaker that has tripped and reset the lever to the on position.