Garage Roof Sheathing Thickness

The inch thick boards extend from the eaves just past the exterior walls where they butt up against the plywood roof sheathing.

Garage roof sheathing thickness.

Roof sheathing may be 1 nominal thickness lumber 7 16 cdx plywood or other approved material. The typical thickness range for sheathing is 3 8 to 3 4 inch. 8d ring shank nails should be used instead. Never attach roof sheathing with staples.

Roof sheathing comes in grid marked 4 by 8 foot sheets and should be installed perpendicular to the frame. 7 16 plywood or similar with span rating of 24 0 supported on 24 centers requires h clips on all horizontal joints centered in each rafter bay. That will suffice on a roof with rafters set 16 inches apart with minimal roof loads. The thickness required by josh s circumstances are good for roof snow loads of up to 70 psf again spanning 24.

That s considered to be the minimum. For the curious 7 16 osb has a span rating of 24 16 and with supports every 24 inches is good for a roof live load of 40 psf pounds per square foot with a 10 psf dead load. Sheathing should be a minimum of 19 32 inch thick. Loads will vary with the.

Roof material then covers all. For heavier loads a 40 20 rated panel 19 32 or 5 8 will support a 130 psf live load and 48 24 rated panels 23 32 or are good to175 psf. In practice many builders default to 1 2 inch plywood even if they plan. Osb is lightweight relatively inexpensive and strong enough to resist bending or breaking should someone walk on the roof.

Roof trusses when used shall be engineered and pre manufactured. Get free estimates from local roofing contractors. In the u s roof sheathing is almost always composed of wood usually osb oriented strand board or plywood. Minimum thickness most roofs will be sheathed in plywood at least 3 8 inch thick.

This minimum will only work if the rafters are set 16 inches apart at most and if the roof doesn t have too much load. If the nails penetrate the sheathing but not the studs the minimum plywood thickness that the irc designates is 1 2 inch. Unlike with plywood siding the plywood sheet to be used for sheathing should be at least 3 8 inch thick. If your roof is more on the flatter side then it s expected to have a heavier load.